Can you have a fused spur in bathroom
If it's mm from edge of bath or shower you are ok. Otherwise it needs to be on outside of bathroom. Hi All, another window question please : Can a C-shaped windowboard be cut off flush to the wall and tiled over? Would this I just want to prep the job. Its no problem digging a channel for the pipe but does it get cemented over or does it have to run in I live in the ground-floor flat in a Victorian terraced house.
I've got a problem with damp on a chimney breast in my kitchen. Hello, I'd like some advice regarding a ceiling extractor fan installation in my bathroom. Every fan I've had keeps tripping the Skip to content Home Assignment Can a fused spur go in a bathroom?
Ben Davis April 21, Can a fused spur go in a bathroom? What is an unswitched fused spur used for? Does a bathroom fan need a fused spur? Can I change a fused spur to a socket? Can you change a switch to a socket? Can you spur off a socket? Can I put 2 double sockets on a spur? How do you tell if a socket is a spur? Can you spur a socket off a light switch? Can I spur off a spur? How many spurs can be on a socket?
How many sockets can be on a ring circuit? How many amps can a 2. Note that there are also some locations that may place water and electricity in close proximity, which are not considered to pose special risks. This include:. Finally you have Kitchens which have their own particular risks - but the requirements are different from bathrooms, and they are not considered a special location in the most recent issue of the part P document.
Bathrooms are divided into zones for electrical purposes. Here's a diagram of them. Unless an installation complies with the latest requirements of the 17th edition i. Note also that when making any changes to an electrical system, one must also ensure that the main equipotential bonding is brought up to current requirements. See Earthing and Bonding for more detail. One fundamental requirement for any electrical equipment be it an appliance or an accessory such as a switch is that it should be suitable for the location.
This means one needs to apply some common sense when choosing and installing equipment. Ordinary electrical light switches are sometimes permitted in a bathroom, however one should only use them where there is no possibility that someone could operate them from the bath or shower.
They also should not be in locations where they are likely to get splashed or have excess steam or vapour directed at them. Traditionally, pull switches are used to mitigate some of these risks. Common alternatives include using conventional switches located outside of the room. Switches will also be required for other devices like heaters or towel rails. Some may be intended for day to day use i. Again, the type of switch selected will depend on where it is going, as well as when you anticipate it being used.
Note that the above zone concepts also apply to lighting in a bathroom. Hence in many cases lighting will need to be specifically designed for the location and be IPX4 rated or better. In larger bathrooms where lighting can be installed outside the zones then one still needs to use common sense in the selection of fittings.
Although conventional mains lamp fittings may be appropriate in large rooms where there is little steam generated typically those with no shower , they would be a poor choice in many cases. Illuminated mirrors are often be placed direct;y above a basin, and in a bathroom this may count as zone 2 unless the light fitting is at least 60cm clear of the taps.
Historically, 13A general purpose mains sockets have not been permitted in bathrooms at all. The 17th edition has introduced a slight relaxation of this, but it will only apply for very large bathrooms since it permits a socket to be installed as long as it is at least 3m from the outer edge of zone 2.
0コメント